This feature is helpful in finding the beginning or the end of the recorded segment on the tape. Press REW to move the tape quickly backward. When in the Stop mode, you can use these buttons to adjust the tape position. Tape playback will be approximately 30-50 percent faster than normal at the MAX position. Slide the switch back to the OFF position to resume activity.ĭuring the playback, you can adjust the speed of the prerecorded tapes by rotating the Variable Speed Playback knob towards the MAX (maximum) position. To use, simply slide the PAUSE switch to the ON position. The PAUSE feature allows you to momentarily stop tape activity in any mode without resetting the control buttons.Press the REW button to rewind the tape to its starting point if necessary.Avoid recording near unwanted noise sources, such as air conditioners, fans, etc.
Note: The ALC (Automatic Level Control) will set the record level for optimum recordings, regardless of the volume setting.
When you finish recording, press the STOP button. To obtain the best recording quality, place the recorder with the microphone freely exposed to sound source and as close as possible. Note: If the RECORD button does not depress, see "Preventing Accidental Erasure." (The PLAY button will automatically be pressed at the same time). Select LO sensitivity for close dictation. Select HI sensitivity for recording at conferences or for general use. Gently slide in a cassette with the exposed tape facing out and the side you want to hear/ record showing through the cassette door window. Grasp both sides of the cassette compartment door and lift up. Note: Make sure all buttons are in their "off" (up) position before attempting to open the cassette compartment door. Increase the volume to the desired level only after headphones are in place. Make sure you turn down the volume on the unit before you put on headphones. When you attach headphones (not included), the speaker is automatically silenced for private listening. Plug the barrel end of the converter into the recorder's 3V DC jack - automatically disconnecting the batteries - and then plug into an AC household outlet. You can use an AC/DC power converter to operate your recorder. Insert two "AA" batteries (not included) as shown in the diagram on the back of the unit. 
Press down on the battery door and slide in the direction of the arrow.
0 kommentar(er)
